End Cap Product Line Expansion Announcement: AG08ALP Center Lift Pipe Sleeves

An already successful product line, the Tandemloc End Cap Spreader Beam Assembly series is getting a new member of the family: the AG08ALP Center Lift Pipe Sleeves. The Center Lift Pipe Sleeves increase the versatility of the Build Your Own Spreader Beam product line by providing users with the option to safely add a third lifting point to their two-point spreader beam assembly. Installation is simple: slide on the corresponding sized pipe, “through-pin” the pipe and sleeve with an attached sleeve-pin and secure with cotter pin. Model sizes vary from 3” to 32” pipe sizes with a maximum capacity rating of 1,544,000 lbs (32” model). AG08ALP Center Lift Pipe Sleeves are designed, manufactured and proof tested in the USA. Build Your Own “Three-Lift-Point Spreader Beam” using AC25C End Caps, Pipe, and AG08ALP Center Lift Pipe Sleeves. Our Center Lift Point Pipe Sleeves further increase the versatility of our Build Your Own Spreader Beam product line by providing users with the option to safely add a third lifting point to their two-point spreader beam assembly. Installation is very simple and similar to that of our Standard Pipe Sleeve: slide on the corresponding sized pipe, “through-pin” the pipe and sleeve with the attached sleeve-pin and secure with included cotter pin. Whenever using the Center Lift Pipe Sleeve, the user must use a 3-leg top sling (even when not using the bottom center lift point provided by the center lift pipe sleeve): with two of the top sling legs attaching to the top hole of the end cap at each end (as is typical with any of our end cap assemblies), and the third leg (center) attaching directly to the top connection point of the center lift pipe sleeve. This center leg in the top sling is required as the spreader is not designed to handle bending loads, which would result if picking up 3 bottom lift points with only a standard (outboard) two leg top sling. *IMPORTANT User Notes: Unlike our Standard Pipe Sleeve, the Center Lift Pipe Sleeve must be located at the center of the spreader beam assembly and cannot be placed at different locations along the length of the beam. A 3-leg top sling must ALWAYS be used with the center lift pipe sleeve, regardless of the bottom configuration of the lift, whether a 2-point or 3-point lift. Please inform your salesperson if your lifter is to be used in an underwater environment. For more information, please visit www.tandemloc.com.